Synergy 8080 - Jeep JK Rear Track Bar Bracket Brace Manuel d'utilisateur télécharger pdf

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397

INSTALLATION INSTRUCTIONS

PPM-8080 JK R TRACK BAR BRACE

GENERAL NOTES:

 These instructions are also available on our website at www.synergymfg.com Check the website for any

updated instructions and additional photos for reference.

 Bracket is designed to be bolted on but can be welded on as well if desired.

PARTS LIST:

 1 - PPM-8080 JK R TB BRACE

 2 - 7/16”-14 UNC 1” long bolt

 1 - 7/16”-14 UNC countersunk bolt

 3 - 7/16”-14 UNC Stover nut

 5 - 7/16” flat washer

 1 - ½-13 UNC bolt 1” long

 1 - ½-13 UNC Stover nut

 2 - ½” flat washer

 1 - 9/16”-12 UNC bolt 3.25” long

 1 - 9/16”-12 UNC Stover nut

 2 - 9/16” flat washer

INSTRUCTIONS:

1) Begin by removing the rear TB bolt and nut at the frame side (#2 in picture below). This is easiest to

do with the vehicle still sitting on the ground under its own weight.

1 2 3 4

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397 INSTALLATION INSTRUCTIONS PPM-8080 JK R TRACK BAR BRACE GENERAL NOTES:  T

Page 2

2) Next, jack up the vehicle and support it using jack stands. Note; suspension does not need to hang free, the vehicle just needs to be supported

Page 3

5) Once all bolts are started (with the exception of the countersunk bolt which requires drilling) tighten the 9/16” TB bolt to fully locate bracket

Page 4

8) Torque bolts as follows:  7/16-14 UNC – 55 ft-lbs.  ½-13 UNC – 80 ft-lbs. 9) Reinstall rear tire and lower vehicle to the ground. Connect T

Pas de commentaire

Synergy 8080 - Jeep JK Rear Track Bar Bracket Brace Manuel d'utilisateur