Synergy 5310 - Jeep JK Rear Bumper Manuel d'utilisateur

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397 PPM-5310 JK REAR BUMPER INSTALL INSTRUCTIONS Version 1 GENERAL NOTES: • T

not contact the plastic on the latch, you may need to install another shim under the latch in order for the latch to operate properly. 38. Contact

6. When removing the stock license plate mount, locate the wire for the license plate light. The wire will need to be lengthened and spliced into

10. Line up the bracket holes with the holes in the frame. 11. Install the license plate with the four ¼” screws, push the new license plate l

11. Now would be a good time to get the license plate light wiring figured out. You may need to add a few feet of wire to the stock light wire and

14. If you are not using a factory installed hitch you can now install the license plate skid plate to the center of the bumper. 15. Place the skid

14. With the new bumper installed and the stock spare tire mount removed; you can begin the installation of the spare tire carrier. 15. Remove the t

Figure 7 24. Install the 1/2” pull pin onto the hub assembly. Grease the spring. We recommend using loctite on the threads of the T-handle. Snu

26. Check the spindle bearing pre-load by lifting the tire carrier. If there is any noticeable up and down movement, tighten the top castle nut mor

Figure 8 34. Install the spare tire mounting bracket to the top of the swing out mount using the four 1/2” x 1” bolts, washers and lock nuts.