Synergy 5013 - Jeep JK Rear Coilover Kit Manuel d'utilisateur

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397 PPM-5013 JK REAR C/O KIT Version 3 GENERAL NOTES: • These instructions are

13) Once shock clearance has been addressed, now is the time to install the rear Currie Antirock sway bar if desired. The sway bar is designed to fit

14) Once c/o clearance and anti rock has been fitted, now the 5013 cross member can be fully welded in. Be sure to clamp the cross-member securely to

16) Fully paint after finish welding. Install shocks, wheels and tires. Torque shock bolts to 80 ft-lbs. Lower to ground and reinstall rear track

PPM-5013 kit fully installed in conjunction with PPM-8078 R HD Lower Shock Mount

2) Next, jack the vehicle up and support it using jack-stands to take the weight of the vehicle off the suspension. ! Remove the rear w

Grind these areas smooth and remove all paint from the inner frame rail between the rear most body mount and the factory shock mount. Also clean the

5) Position the new 5013 cross member and clamp into place as shown. The cross-member flanges locate it against the bottom of the frame and against

6) At this time, it is recommended that shocks be installed and suspension be fully cycled to ensure proper shock lengths and bump stop spacers are u

8) Do one side at a time, so that measurements can be taken from the factory mounts on the opposing side. Begin by cutting off the factory LCA brack

10) With the RLCA brkt tacked securely on, set the axle at ride height, reattach track-bar, and center the axle. Now, using the 807204-02 shock tab

11) With tabs positioned, cycle suspension from bump to droop to ensure no binding is occurring. Now is also a good time to trim the 807204-05 low